Indoor LED Light PCB Installation Guide

Indoor LED Light PCB Installation Guide
Now Indoor LED Light PCB because of its light, thin, soft, long life, safety and other characteristics, more and more applications in the decoration industry. But because the Indoor LED Light PCB is a new product, many customers have not used, for how to install do not understand.
1, indoor installation: Indoor LED Light PCB for interior decoration, because do not have to withstand wind and rain, so the installation is very simple. With the indoor LED Light PCB manufactured by Rainbow Electronics, for example, each Indoor LED Light PCB is covered with self-adhesive 3M double-sided adhesive, the installation can be directly peeled 3M double-sided adhesive surface of the sticker, and then fixed the light In the need to install the place, just by hand like a flat. As for some places need a corner or how long do? Very simple, light band is a group of three LEDs as a series of parallel connection of the circuit structure, 3 LED LED can be cut every single use.
2, outdoor installation: outdoor installation will withstand wind and rain, if the use of 3M glue fixed, then a long time will cause 3M to reduce the adhesion caused by Indoor LED Light PCB off, so the outdoor installation is often used card slot fixed way The Need to cut and connect the place, methods and indoor installation, just need to be equipped with another waterproof glue to consolidate the connection point of the waterproof effect.
3, power connection method: Indoor LED Light PCB general voltage is 12V DC, so need to use the switching power supply, the size of the power according to Indoor LED Light PCB power and connection length to set. If you do not want each Indoor LED Light PCB to use a power supply to control, you can buy a relatively large power supply switching power supply to do the total power, and then all the Indoor LED Light PCB input power all the parallel (wire size is not enough to extend the other ), Unified by the total switching power supply. This is the advantage that can be centralized control, inconvenient place is not able to achieve a single Indoor LED Light PCB lighting effects and switch control, the specific use of which way can be measured by their own.
4, the controller connection: Indoor LED Light PCB and RGB full color light with the need to use the controller to achieve the effect of change, and the control of each controller is not the same distance, in general, the simple control of the controller distance of 10 to 15 meters, the remote control of the control distance of 15 to 20 meters, the longest can be controlled to 30 meters distance. If the connection distance of the Indoor LED Light PCB is long and the controller can not control such a long lamp, then a power amplifier is required for tapping.
5, attention Indoor LED Light PCB connection distance: In general, 3528 series Indoor LED Light PCB, the connection distance of up to 20 meters, 5050 series Indoor LED Light PCB, the longest connection distance of 15 meters. If it exceeds this connection distance, Indoor LED Light PCB is easy to heat, the use of the process will affect the indoor LED Light PCB life. Therefore, the installation must be in accordance with the requirements of manufacturers to install, should not let Indoor LED Light PCB overload operation.
From the color points, Indoor LED Light PCB with "colorful" "white" "warm white" "red" "green" "yellow" "blue" and so on. In theory, LED can bring up a lot of color, but the mainstream is so few, according to the different color temperature, there will be some "deviation." For example, "warm white" on the sub-2000K and 4000K color temperature, "white" cool white, close to the sun's color "white" and so on. According to our delivery statistics. Shipping is the largest "warm white", followed by the "white" to the yellow, blue. Other colors are very few. To "warm sense" to choose "warm white"; to "light sense" to choose "cool white"; to "fashion sense" to choose "blue" to "alternative" to choose "yellow or green"...